Nomadtech
Reference: NOM-1102008SET
Zestawy Naprawcze
Suzuki Samurai Rear Axle Stud Set, 8 pcs
A set of eight rear axle studs for the Suzuki Samurai. Threaded shank, hexagonal shoulder flange and a zinc-plated anti-corrosion finish — you renew all the studs at once instead of leaving a mix of fresh and worn threads in the hub. A natural addition to any rear axle or brake overhaul.
Suzuki Samurai Rear Axle Stud Set — 8 pcs
Studs are the part nobody thinks about until one snaps during tightening, or until a thread that has spent years under grit and rusted nuts refuses to take proper torque. On an off-road vehicle there is no room for compromise here — this joint carries the drive and the entire wheel load.
A set of eight studs for the Samurai rear axle lets you renew them all at once instead of leaving a mix of fresh and worn threads in the hub. Each stud has a threaded shank, a hexagonal shoulder flange and a zinc-plated anti-corrosion finish.
Contents 8 studs for the rear axle | Fitment Suzuki Samurai |
Key benefits
- Eight pieces in one set, so the whole rear axle gets fresh studs rather than a mix of old and new.
- Zinc plating resists corrosion in a location that lives in salt, mud and standing water all year round.
- Undamaged threads let the joint be torqued properly — the precondition for nuts that stay tight on a long drive.
What is in the box
- 8 studs
Technical data
- Quantity: 8 pcs
- Position: rear axle
- Construction: threaded shank with hexagonal shoulder flange, zinc-plated finish
- Application: Suzuki Samurai
The set makes sense for anyone stripping a Samurai rear axle for bearings, seals or brake work — that is the right moment to renew the studs as well. It is also the obvious purchase after any incident with a snapped or stretched stud.
Fitting notes
- Before ordering, compare the length and thread with the studs currently fitted to your car — Samurais are often rebuilt over the years and studs get swapped for non-original ones.
- Torque the nuts with a torque wrench, in a crosswise pattern.
Why it is worth it
- An inexpensive part that the wheel literally hangs on — not the place to economise.
- A full set rather than single pieces, so the repair does not stop halfway.
- Zinc plating is a real advantage over reused, corroded studs pulled off during disassembly.
If you want to be certain the set matches your rear axle configuration, send us a photo of the hub and we will check it before shipping.
Frequently Asked Questions
How many studs are in the set?
Eight pieces.
Which axle are these studs for?
For the rear axle of the Suzuki Samurai.
Are the studs corrosion-protected?
Yes, they have a zinc-plated finish, clearly visible in the product photos.
When is the best time to replace them?
While the rear axle is apart for bearings, seals or brake work, and always after a stud has snapped or been stretched.
