Shocks
Sekureco Shock Absorber Nissan Patrol Y60/Y61 Front +2''
Front Sekureco shock absorber for the Nissan Patrol Y60/Y61, matched to a +2'' (+5 cm) lift. Sold as a single unit, tuned for everyday driving with comfortable reserve off the tarmac.
Sekureco Shock Absorber Nissan Patrol Y60/Y61 Front +2''
A lifted suspension only pays off when the shocks are valved for the new ride height - stock units tuned for factory geometry tend to feel loose and don't use their travel the way they should. This front Sekureco shock is built specifically around a +2'' (+5 cm) lift, so it works in the geometry your Patrol actually sits in once it's been raised.
| Manufacturer | Sekureco |
| Mounting position | Front |
| Dedicated lift | +2'' (+5 cm) |
| Compatibility | Nissan Patrol Y60 (1987-1996), Nissan Patrol Y61 (1997-2006) |
| Sold as | Single unit |
Key benefits
- Valving matched to a lifted +2'' suspension rather than to the factory ride height
- Available as a single unit when you only need to replace one side of the front axle
- Confirmed fitment for both the older Y60 generation and the later Y61
Technical data
The distributor's product page does not publish detailed figures such as travel length, body diameter, or the type of fill used - the only confirmed specifications are the +2'' lift application and Patrol Y60/Y61 compatibility.
It's sold as a single shock for front-axle installation - suited to completing a set or swapping out one side, rather than to building an entire suspension from scratch.
Why it's worth it
- You get a shock valved for your actual lift range instead of guessing whether a stock-spec unit can handle the extended travel
- Buying a single unit keeps cost down when you don't need a full set
If you're completing the front end of your Patrol's +2'' lift, this shock closes out the spec without hunting for a substitute meant for a different lift height.
Frequently Asked Questions
Does this shock fit both the Y60 and Y61?
Yes, the manufacturer confirms compatibility with the Nissan Patrol Y60 (1987-1996) and Y61 (1997-2006).
Can I buy just one shock, or only as a set?
This product is sold as a single unit, so you can order one shock for the front axle without buying a full kit.
Will this shock work on a stock, non-lifted suspension?
No - it is valved specifically for a +2'' (+5 cm) lifted suspension, not for factory ride height.
Which end of the vehicle is this shock for?
This is the front shock. The rear counterpart for the same +2'' lift is listed under NOM-3102002.