Sekureco Shock Absorber Nissan Patrol Y60/Y61 Rear +2''

Once the suspension is lifted, the rear axle moves through a different travel range than it did from the factory - keep the stock rear shock and stability suffers right where it matters. This rear Sekureco shock is valved for a +2'' (+5 cm) lift and completes the suspension setup on a Nissan Patrol Y60/Y61.

Key benefits

• Valving matched to a rear axle lifted by +2'' rather than to factory ride height
• Available as a single unit when only one side of the rear needs replacing
• Confirmed fitment for both the Y60 and the Y61

Technical data

The distributor's product page does not publish detailed figures (travel, body diameter, fill type) - the confirmed specifications are the +2'' lift application and Patrol Y60/Y61 compatibility.

It's sold as a single shock for rear-axle installation - suited to completing a set or replacing one side, rather than building a full suspension from scratch.

Why it's worth it

• Matched to your actual lift range instead of running a stock-spec shock past its intended travel
• Buying a single unit keeps cost down when a full set isn't needed

If the front of your Patrol is already set up for a +2'' lift, this shock closes out the rear axle to the same spec.

Frequently Asked Questions

Does this shock fit both the Y60 and Y61?

Yes, the manufacturer confirms compatibility with the Nissan Patrol Y60 (1987-1996) and Y61 (1997-2006).

Can I buy just one shock, or only as a set?

This product is sold as a single unit, so you can order one shock for the rear axle without buying a full kit.

Will this shock work on a stock, non-lifted suspension?

No - it is valved specifically for a +2'' (+5 cm) lifted suspension, not for factory ride height.

Which end of the vehicle is this shock for?

This is the rear shock. The front counterpart for the same +2'' lift is listed under NOM-3102001.