Annex for the Overlander Explorer 3.0 140 cm Roof Tent

A few days in one spot and a roof tent starts to feel tight – not on the bed, but when you need somewhere to put boots, gear and wet clothing. The annex adds a sheltered room 1.4 m high beneath the tent.

This version is designed for the 140 cm wide Overlander Explorer 3.0 and joins it as an extension running down to vehicle level.

Key benefits

• 1.4 m ceiling height – enough to change sitting up and to stow kit inside instead of leaving it in the car or under a tarp.
• Tear-resistant Oxford polyester in 420D – fabric that copes with rubbing on edges and with daily setup.
• PU2000 mm+ waterproof rating – the polyurethane coating handles rain, not just drizzle.
• Breathable fabric – air circulates, so heat does not build up the way it does under a sealed sheet.
• 550 g PVC outer coating – an extra barrier against dust, dirt and weather.
• Large SBS zip – it works on every entry and exit, so its durability carries the whole annex.
• Door with access to the vehicle – move between the annex and the car without stepping into the rain.

Technical data

• Designed for: the 140 cm wide Overlander Explorer 3.0 roof tent
• Ceiling height: 1.4 m
• Body: tear-resistant Oxford polyester, 420D
• Waterproof rating: PU2000 mm+ (polyurethane coating)
• Outer coating: PVC, 550 g
• Zip: SBS, large
• Entrance: door giving access to the vehicle

Who it is for. For owners of the Explorer 3.0 140 cm who set up camp for longer: expeditions with a lot of kit, trips into wet regions, and anywhere a sheltered passage between vehicle and tent earns its keep.

Fitting notes

The annex is matched to the 140 cm wide Overlander Explorer 3.0 – check which version of the tent you own before ordering, because annexes are matched to a specific model and width.

If you are not sure the annex suits your tent configuration, drop us a line – Szekla4x4 runs an overland workshop next to the shop and we will check it with you.

Why it is worth it

• You enlarge the tent you already own instead of buying a bigger model.
• Shell figures stated as numbers: 420D, PU2000 mm+, 550 g PVC coating.
• A covered area at the vehicle turns a roof tent into a small base camp rather than just a place to sleep.

It is the simplest way to make room under the tent for boots, packs and getting changed in the rain.

Frequently Asked Questions

Which tent does this annex fit?

The 140 cm wide Overlander Explorer 3.0 roof tent.

How tall is the annex inside?

The ceiling height is 1.4 m.

What are the fabric figures?

Tear-resistant Oxford polyester in 420D, rated PU2000 mm+ thanks to a polyurethane coating. The outer coating is 550 g PVC.

Is there an entrance on the vehicle side?

Yes, it has a door that gives access to the car.

What quality is the zip?

A large SBS zip, designed for frequent use.