Raptor 4x4
Reference: RAP-15152
Shocks
Rear Shock Absorber +6 cm Lift Toyota Land Cruiser 70 KZJ/LJ Square Lamp
A Raptor 4x4 rear shock absorber intended for a +6 cm lift on a square lamp Toyota Land Cruiser KZJ/LJ 70. The longer stroke lets the rear wheel drop further, so the truck holds traction better on twisted ground. Weighs 3 kg; square lamp body.
Rear Shock Absorber +6 cm Lift, Toyota Land Cruiser 70 KZJ/LJ — Square Lamp (Raptor 4x4, part 15152)
A lifted rear end without a longer damper looks right in the car park and disappoints on the first ledge — the wheel only drops as far as the shock lets it. This Raptor 4x4 rear damper is dimensioned for a lift of around 6 cm, so the rear axle can actually use the travel the lift created.
The part number covers the KZJ 70 / LJ 70 with the square lamp body. Round lamp cars have separate part numbers in the manufacturer catalogue, in some cases even side-specific.
Fitment Land Cruiser KZJ 70 / LJ 70, square lamp | Designed for +6 cm lift (approx. +2") | Axle Rear |
Key benefits
- Length calculated for a +6 cm lift — the rear wheel droops further, so the truck keeps traction on twisted ground.
- Completes the lift spring package — the same manufacturer builds +6 cm rear springs for the same body version.
- 3 kg — this is unsprung mass, so every kilogram counts for how the suspension follows the ground.
- Unambiguous fitment — listed directly against the square lamp body.
Technical data
- Manufacturer part number: 15152
- Manufacturer: Raptor 4x4 (Saglietti S.r.l., Italy)
- Axle: rear
- Intended lift: +6 cm
- Body version: square lamp (faro quadro), KZJ 70 / LJ 70
- Weight: 3 kg
Who it is for. A lifted square lamp 70-series used off road and on long trips, especially one that carries weight at the back. If you are fitting a set of rear lift springs, this damper is their natural partner.
Fitting notes
Replace in pairs, one full axle at a time — mixing a new damper with a worn one gives uneven damping and unpredictable rear-end behaviour under braking on broken surfaces. Check the rubber bushes in the mounts while the shock is out. Our workshop builds and services off-road suspension, so we can put the whole lift together for you.
Why buy this shock
- Designed for a specific lift height rather than picked by eye.
- One coherent catalogue: springs, dampers and hardware for the 70-series from a single manufacturer.
- The square lamp designation removes the most common ordering mistake in this range.
Putting together a full suspension package? Get in touch and we will match front and rear for an even lift.
Frequently Asked Questions
Is this a single unit?
Yes, the manufacturer lists this part number as one shock absorber. Two are needed for the rear axle.
Does it fit the round lamp version?
No. The manufacturer assigns this part number to the square lamp (faro quadro) body; round lamp cars have separate catalogue entries.
What lift is it designed for?
A lift of around 6 cm, roughly 2 inches.
How much does it weigh?
3 kg, as stated by the manufacturer.
