Bonnet Scoop — Ford Ranger T9 2023+

One part you will spot from ten metres away. The scoop sits on the rear section of the bonnet and gives the Ranger a raised intake with three transverse fins, while the side pieces extend it along the rear edge of the panel — in the photo the whole assembly is matt black and contrasts with the body paint.

The supplier assigns it to the Wildtrak, Limited and XLT trims. It does not fit the Ranger Raptor — the supplier rules it out explicitly.

Key features

• In the photo: a raised panel with three transverse fins, seated on the rear part of the bonnet
• Additional side pieces extend the scoop along the rear edge of the panel, with a mesh section at each end
• Matt black finish, contrasting with the body paint
• Glued on — no drilling into the bonnet
• Does not fit the Raptor

Technical data

• Supplier catalogue number: TXT9 006
• Application: Ford Ranger T9 2023+ — Wildtrak, Limited, XLT
• Contents: bonnet scoop together with additional side pieces
• Fitting: glued on
• Excluded trims: Raptor

Fitting and notes

Do a dry fit before you glue anything. In the photo the part reaches the rear edge of the bonnet, right by the wiper blades — check it does not foul the wiper arms or the washer jets. Wash and degrease the surface and work above freezing — acrylic adhesive only reaches full strength after a day or two.

The supplier does not say whether the adhesive comes pre-applied, nor what material the scoop is made from. The intake looks closed in the photo and the supplier describes no airflow into the engine bay — treat it as a styling part only.

Frequently asked questions

Is the intake functional?

The supplier says nothing about it and the intake looks closed in the photo. It is a styling part, not an air feed.

Does it fit the Raptor?

No. The supplier excludes the Raptor explicitly.

Can it be removed without a trace?

The supplier does not cover this. The part is glued on, and removing it usually means heating it and cleaning off the adhesive.