Bumpers and Bullbars
Front Bumper Overlay Mitsubishi L200 / Triton 2020+
A front bumper overlay for the Mitsubishi L200 / Triton from model year 2020. Made of ABS, factory-painted and bonded onto the bumper. In the photo it forms a two-tone black and silver lower bumper section with red accents at the corners of the vehicle.
Front Bumper Overlay — Mitsubishi L200 / Triton 2020+
The facelifted L200 front end is sharp, but the lower part of the bumper stays flat and plain. This overlay fills that area with a two-tone panel that adds visual mass to the front of the truck and gives it a prepared, off-road look — without touching anything structural.
The supplier keeps it short: ABS material, painted as shown in the photos, bonded onto the bumper. The vehicle photo shows the overlay covering the lower bumper across its full width, with a silver bar through the centre, black vertical contours, red inserts at the corners and XTREAMER lettering embossed into the black section.
Fits Mitsubishi L200 / Triton from 2020 | Fitting Bonded to the factory bumper | Material ABS, factory-painted |
Key features
- A purely cosmetic part — the supplier claims no protective or load-bearing function
- Bonded on, with no need to replace the factory bumper
- Factory-painted — no respray needed before fitting
- In the photo: black and silver finish with red accents at the corners
Technical data
- Part number: TXYH TL030
- Material: ABS
- Finish: painted, as shown in the photos
- Application: Mitsubishi L200 / Triton from 2020
- Fitting method: bonded to the bumper
Fitting and notes
The supplier only states that the overlay is bonded to the bumper — it does not say whether tape or adhesive is included. Check that with the seller. The bumper surface has to be washed, degreased and dry, and bonding should be done above freezing.
The overlay sits lower than the standard bumper, so your effective approach angle will be reduced. Also check whether your bumper has parking sensors or fog lights — the supplier does not state whether the overlay is cut out for them.
Frequently asked questions
Does the overlay replace the factory bumper?
No. The supplier describes it as a part bonded onto the existing bumper.
Is it protection for off-road use?
No. It is a bonded ABS overlay described as a styling change, not a bull bar or underbody guard.
Does it fit an L200 built before 2020?
The supplier states model year 2020. For earlier bumpers confirm with the seller.
