Bonnet Deflector Jeep Renegade

A deflector fitted to the front edge of the Jeep Renegade bonnet. In the photo it is a dark, semi-transparent profile that spans the full width of the bonnet and follows its line.

The job of the deflector is simple: divert the airflow so that whatever it carries — insects, dust, small gravel thrown up by the cars ahead — passes over the roof instead of hitting the bonnet and windscreen. The front edge of the bonnet takes the worst of it and is the first place to pick up paint chips.

Key features

• Takes the hits from insects and small stones aimed at the bonnet
• Reduces paint chipping on the leading edge of the bonnet
• Diverts the dirt-laden airflow over the roof of the vehicle
• Profile shaped along the Renegade bonnet line (as shown in the photo)

Fitting and notes

The supplier does not describe the fitting method, nor state whether screws, clips or tape are included. The photo shows mounting points spaced along the bonnet edge. No material or manufacturer is given either — if that matters before you buy, write to us and we will check with the supplier. Wash and degrease the bonnet edge before fitting.

Frequently asked questions

Which Renegade model years does it fit?

The supplier gives the model only — Jeep Renegade, with no years. The photo shows a facelift Renegade. Tell us your model year before ordering and we will confirm the fit with the supplier.

Will the deflector fully protect the bonnet paint?

No. It diverts the main airflow and takes some of the impacts at the leading edge. It is not a substitute for protective film over the whole bonnet.

Does the bonnet have to be drilled?

The supplier does not say. Before ordering, check with us what mounting method the manufacturer of this deflector uses.