Fender Flares and Extensions
TopFire Fender Flares Ford Ranger Wildtrak T8 2019-2022 — with PDC Cutouts
Fender flares for the Ford Ranger Wildtrak T8, model years 2019-2022, in the version with pre-cut openings for PDC parking sensors. Made from 3 mm ABS with a UV additive, matte, finely textured and finished with rivets. The supplier states they widen the vehicle by approx. 50 mm and seal against the body with a rubber gasket instead of 3M tape.
TopFire Fender Flares Ford Ranger Wildtrak T8 2019-2022 — with PDC Cutouts
A fender flare set for the Ford Ranger in Wildtrak trim. The supplier lists a fit for model years 2019-2022. This is the version prepared for parking sensors — the sensor openings are already cut, so you do not have to drill the flares themselves.
Beyond the looks, flares shield the wheel arch area from stones and mud thrown by wider tyres. The supplier states an added width of approx. 50 mm.
Application Ford Ranger Wildtrak T8, 2019-2022 | Material 3 mm ABS with UV additive | PDC sensors Openings pre-cut |
Key features
- Version with openings for PDC parking sensors
- 3 mm ABS with a UV additive — matte colour and a fine surface texture
- Riveted finish, typical of the off-road look
- Seals against the body on a rubber gasket — the supplier does not use 3M tape here
- Mounts on the original clips and screws, without piercing the vehicle body
Technical data
- Application: Ford Ranger Wildtrak T8
- Model years per supplier: 2019-2022
- Material: ABS, 3 mm thick, with UV additive
- Finish: matte, fine texture, rivets
- Added width: approx. 50 mm (per supplier)
- Sealing: rubber gasket where the flare meets the body
- Included: mounting hardware in a box — rivet bolts, self-tapping screws
Fitting and notes
Per the supplier, fitting uses the original clips and screws with no drilling into the sheet metal. The photo shows the inner side of a flare: a black part with pre-set studs and clips and a nut on a reinforced mounting point. The supplier does not state the piece count — we will confirm it with the distributor.
Frequently asked questions
Do they fit a Ranger without parking sensors?
This variant has permanent PDC cutouts. For vehicles without sensors the supplier offers a separate part number — flares without openings.
Is drilling into the body required?
According to the supplier, no. Fitting uses the original clips and screws without piercing the vehicle surface.
Why no 3M tape?
The supplier uses a rubber gasket where the flare meets the body. No bonding step and no adhesive residue on removal.
