Body Accessories
Flag Mount for US Hitch Receiver — Steel Bracket for Square Receiver
Steel bracket for mounting a flag on a vehicle with a US-type hitch. It slides into the square receiver in place of the tow ball. The photo shows a vertical sleeve for the pole, a welded gusset and two thumb screws that lock the pole without tools. Finished in black.
Flag Mount for a US Hitch Receiver
If your vehicle has a US-standard hitch — a square receiver taking interchangeable inserts — this bracket gives you a ready-made home for a flagpole. It slides into the receiver in place of the ball, so the flag rides at the back of the vehicle rather than on the roof or in the boot.
The supplier states the bracket is steel, finished in black, and that it mounts in the square opening instead of the hitch ball.
Application Vehicles with a US-type hitch | Material Steel | Colour Black |
Key features
- Slides into the square US receiver in place of the tow ball
- Vertical sleeve takes a flagpole (shown in the photo)
- Two thumb screws with plastic knobs lock the pole without tools (shown in the photo)
- Welded gusset stiffens the joint between sleeve and bar (shown in the photo)
- Several holes in the bar, so the stick-out from the receiver can be set (shown in the photo)
Technical data
- Material: steel
- Colour: black
- Mounting: in the square hitch receiver, in place of the ball
- Intended use: flag mounting
Fitting and notes
The bracket goes into the receiver and is held by the hitch pin, like any other US insert. The supplier does not state the receiver size (1.25 in or 2 in), the internal diameter of the pole sleeve, or whether a pin and clip are included. Maximum pole height and flag size are not stated either. Contact us before ordering if any of these is critical for you. Also bear in mind that anything projecting beyond the vehicle outline must not obscure the number plate or the lights.
Frequently asked questions
Will it fit my hitch?
The supplier only states that the bracket is for vehicles with a US-type hitch and mounts in the square opening in place of the ball. Receiver size is not given — measure yours before ordering and contact us if in doubt.
Is the flagpole included?
The supplier describes the bracket only. A pole and flag are not listed as part of the set.
Can it be removed for towing?
Yes — the bracket occupies the same receiver as the ball, so the two are interchangeable. Pull it out for towing and refit the ball.
